OH-118-A5 |
| Electrical/Optical Characteristics
(Ta=25 °C) |
| Item |
Symbol |
Conditions |
Min |
Typ |
Max |
Unit |
| Operating Voltage |
VCC |
 |
4.5 |
- |
5.5 |
V |
| Consumption Current |
ICC |
VCC=5V,
VOUT=OPEN
(average value) |
- |
- |
15 |
mA |
| Output Voltage, Low |
VOL |
IOUT=16mA |
- |
0.1 |
0.4 |
V |
| Output Voltage, High |
VOH |
VCC=5V |
4.9 |
- |
- |
V |
| Response Time |
tFHL |
Note
1 |
- |
- |
1.0 |
ms |
| tFLH |
- |
- |
1.0 |
ms |
|
|
 |
|
| |
| Detecting Output |
Low when Detecting |
| Detecting Distance |
VCC=5V
90% Reflection Paper (Kodak) |
5 ±4 mm |
VCC=5V
Value N5.5 color chip (non-glossy) |
5 ±2 mm |
| Ambient Luminance |
3,000 LUX Max.
Incandescent lamp or 50 - 60 Hz Fluorescent Lamp |
|
| |
| Note 1: |
 |
| |
| Mechanical Characteristics |
|
| Vibration Resistance |
To withstand 10~55~10Hz, 1.5mm amplitude
and 1 minute sweep time in X, Y and Z directions, each for
2 hours. |
| Shock Resistance |
294m/S2 (30G) or more. |
| Tightening Torque |
4 kgf·cm (0.392 N·m Max
(By hand or electric driver) |
|
| |
| Outer Dimensions |
|
 |
| |
| Connection Diagram |
|
|
| |
| Components |
|
| No. |
Description |
Qty. |
Materials |
Remarks |
| 1 |
Case |
1 |
PBT (G15%) |
Flammability: UL94V-2 or more |
| 2 |
Case |
1 |
PBT (G15%) |
Flammability: UL94V-2 or more |
| 3 |
Lens |
1 |
Acryl Resin |
UL-94HB |
| 4 |
Connector |
1 |
175768-3 |
AMP (Natural) |
| 5 |
Printed Circuit Board |
1 |
FR-4, CEM-3 |
UL-94V-0 |
|
| |
| Handling Notes |
|
- Careful attention should be made to avoid deformation of
components.
- Environmental air must be free from corrosive gasses such
as hydrogen sulfide or salt water air.
- Mount sensor away from direct sunlight and incandescent light.
- The side with emitting and receiving elements should be handled
very carefully.
- Do not wash sensors. Liquid may get into the case and cause
damage. If you must clean the surface area, use a soft cloth
damped with a washing fluid such as methanol or isopropyl alcohol.
- Degrading LED radiant power should be addressed if sensor
is used repeatedly over a long period of time.
- This product was designed for use in the following applications:
- OA equipment, video equipment, consumer electronics, communication
equipment, measuring equipment, and control equipment.
- When designing a system for safety and reliability, be
sure to incorporate fail-safe and other appropriate measures
|
| |
